Pioneer SC-LX801 Basic Manual page 53

> Specifications > Settings
■ Dolby Enabled Speaker
Setting Item Default Value
Dolby Enabled 6' 00" / 1.80 m
Speaker to
Ceiling
Reflex Optimizer Off
• This setting can be selected when "System Setup" - "Speaker" - "Configuration" - "Height 1
Speaker"/"Height 2 Speaker" is set to "Dolby Speaker".
> Listening Modes > Playback Function
Setting Details
Set the distance between the Dolby Enabled
Speaker and the ceiling. Select between " 0' 0" 1/2
"/"0.01 m" to " 15' 0" "/"4.50 m" (1/2 / 0.01 m units).
• The unit of distance (feet / meters) shown is the
unit selected for use in "Distance".
You can enhance the reflection effect of Dolby
Enabled Speakers from the ceiling.
"Off": Do not use this function
"On": Use this function
• The function is not effective if the listening mode
is Pure Direct.
Audio Adjust
Make advanced settings such as those related to multiplex audio or those related to the
volume of this unit.
■ Dual Mono/Mono
Setting Item Default Value
Dual Mono Main
Mono Input Left+Right
Channel
■ Dolby
Setting Item Default Value
Loudness On
Management
> Basic Manual
Troubleshooting | Appendix
Setting Details
Set the audio channel or language to be output
when playing multiplex audio or multilingual TV
broadcasts etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels will be output
at the same time.
• If multiplex audio is being played, "1＋1" will be
displayed when on the remote controller is
pressed.
Set the input channel to use for playing any 2 ch
digital source such as Dolby Digital, or 2 ch analog/
PCM source in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left+Right": Left and right channels
Setting Details
When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume
of dialog at a certain level. Note that when this
setting is Off, the DRC function that allows you to
enjoy surround at low volumes is fixed to off when
playing Dolby Digital Plus/Dolby TrueHD.
"On": Use this function
"Off": Do not use this function
17