Pioneer SC-LX801 Basic Manual page 48

> Specifications > Settings
Setting Item Default Value
Height 2 Speaker Rear High
12
> Listening Modes > Playback Function
Setting Details
Set the speaker type if height speakers are
connected to the HEIGHT 2 terminals. Select
"Front High", "Top Front", "Top Middle", "Top
Rear", "Rear High", "Dolby Speaker (Front)",
"Dolby Speaker (Surr)", or "Dolby Speaker (Back)"
according to the type and layout of the connected
speakers. However, the options selectable for the
"Height 1 Speaker" the are as follows.
If "Height 1 Speaker" is set to "Front High": Select
from "Top Middle", "Top Rear", "Rear High", "Dolby
Speaker (Surr)", or "Dolby Speaker (Back)".
If "Height 1 Speaker" is set to "Top Front" or "Dolby
Speaker (Front)": Select from "Top Rear", "Rear
High", "Dolby Speaker (Surr)", or "Dolby Speaker
(Back)".
If "Height 1 Speaker" is set to "Top Middle": Fixed
to "Rear High".
• "Dolby Speaker (Surr)" and "Dolby Speaker
(Back)" can only be selected when surround
speakers or surround back speakers are being
used, respectively. You can check speakers that
you are using on the figure displayed in "System
Setup" - "Speaker" - "Configuration" - "Speaker
Channels".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
Setting Item Default Value Setting Details
Zone Speaker No Set the connection of speakers to Zone 2 or Zone
3 speaker terminals.
"Zone 2": When speakers are connected only to
Zone 2 speaker terminals
"Zone 2/Zone 3": When speakers are connected to
both Zone 2 and Zone 3 speaker terminals
"No": When speakers are not connected to either
speaker terminals
Speaker B No Set whether you will use the Speaker B system.
"No": Speaker B system will not be used
"Yes": Speaker B system will be used without bi-
amp connection
"Bi-Amp": Speaker B system will be used with bi-
amp connection
> Basic Manual
Troubleshooting | Appendix
• "Zone 2/Zone 3" cannot be selected when
surround back speakers and height speakers
are being used.
• This item will be set to "No" when two sets of
height speakers are being used.
• "Bi-Amp" cannot be selected when height
speakers are being used.
• In any of the following cases, this item will be
set to "No":
– When "System Setup" - "Speaker" -
"Configuration" - "Zone Speaker" is set to
other than "No"
– When two sets of height speakers are being
used