Pioneer SC-LX801 Basic Manual page 65

> Specifications > Settings
Miscellaneous
Change the frequency step for the tuner, update the firmware, and perform Initial Setup,
etc.
■ Tuner
Setting Item Default Value
AM / FM 10 kHz / 0.2 MHz Select a frequency step depending on your area of
Frequency Step
(North American
models)
AM Frequency 9 kHz
Step (European
and Asian
models)
AM Noise Cut 1
Mode
> Listening Modes > Playback Function
Setting Details
residence.
Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz".
• When this setting is changed, all radio presets
are deleted.
Select a frequency step depending on your area of
residence.
Select "10 kHz" or "9 kHz".
• When this setting is changed, all radio presets
are deleted.
You can improve reception sensitivity by changing
this mode if you are finding AM broadcasts difficult
to hear. Select "1" or "2".
■ Remote ID
Setting Item Default Value
Remote ID 1
> Basic Manual
Troubleshooting | Appendix
Setting Details
Select an ID for the unit's remote controller from
"1", "2", and "3" to prevent interference between
the unit and other Pioneer components that are
installed in the same room. After changing the ID
on the main unit, change the ID on the remote
controller accordingly with the following procedure.
While holding down MODE, press the following
buttons for about 3 seconds.
• To change the remote controller ID to "1":
(The remote indicator flashes once.)
• To change the remote controller ID to "2":
(The remote indicator flashes twice.)
• To change the remote controller ID to "3":
(The remote indicator flashes three times.)
29