Advertisement
Quick Links
AUTOMATIC DIALING TELEPHONE
EQUIPPED WITH ADI2.01 FIMWARE
Communication Equipment
& Engineering Company
SERVICE MANUAL
FOR
MODEL SSC-303-D
(FORMERLY 303-DS)
STAINLESS STEEL
Sold by:
SSC-303-D(303DS)-ADI2.01-650-541-ISSUE4.0
http://www.TWAcomm.com
Toll Free: (877) 892-2666
Serving the Telephone Industry Since 1930
th
1580 NW 65
Avenue
Plantation, FL 33313
Voice: 954-587-5430
Fax: 954-587-5440
Advertisement
Related Manuals for CEECO SSC-303-D
Summary of Contents for CEECO SSC-303-D
- Page 1 SSC-303-D(303DS)-ADI2.01-650-541-ISSUE4.0 SERVICE MANUAL MODEL SSC-303-D (FORMERLY 303-DS) STAINLESS STEEL AUTOMATIC DIALING TELEPHONE EQUIPPED WITH ADI2.01 FIMWARE Sold by: http://www.TWAcomm.com Toll Free: (877) 892-2666 Serving the Telephone Industry Since 1930 Communication Equipment 1580 NW 65 Avenue & Engineering Company Plantation, FL 33313...
- Page 2 ISSUE 4.0 IMPORTANT INFORMATION CUSTOMER Please fill in before you continue. The following information is necessary when calling CEECO for assistance. MODEL NUMBER MODEL SSC-303-D EQUIPPED WITH ADI2.01 FIRMWARE. SERIAL NUMBER DATE MANUFACTURED LOCATION INSTALLED For us to better serve you, please have this information available when calling for technical support.
-
Page 3: Table Of Contents
RECOMMENDED TOOLS AND TEST EQUIPMENT ........7 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS ..... 8 SPECIFICATIONS....................9 FCC NOTICE......................10 PARTS LIST ......................11 10.0 REPAIR AND RETURN INFORMATION............12 11.0 WARRANTY POLICY ..................13 12.0 DIAGRAM......................14 CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 4: Introduction
INTRODUCTION The practices in this manual provide installation and maintenance information for the Model SSC-303-D Stainless Steel Automatic Dialing Telephone. The information in this manual is subject to change without notification. For information not included in this manual, please call or write:... -
Page 5: Programming
“1” for Digit 1, under the #00 programming location (refer to next section-3.7). You must also make selections for Digits 2 and 3 accordingly. Location #19 must be used in order to use Location #20. CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 6: Programming Continued
Programming is now completed. Hang up the phone and return the two plastic mini-jumpers to the “OFF” position as depicted on the last page of this manual. The phone is now ready for Testing/Operation. CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 7: Testing/Operation
RECOMMENDED TOOLS AND TEST EQUIPMENT DTMF Test Set Volt/Ohm Meter 1/4" Nut Driver 5/16" Nut Driver Flat Blade Screw Driver Security Tool 301-037 CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 8: Installation Notes And Assembly Instructions
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. Use caution when installing or modifying telephone lines. CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 9: Specifications
Standard Coinless Public Telephone footprint MEMORY RETENTION: Lithium Battery – Long Life WEIGHT: Approximately 17 Pounds FCC REGISTRATION: BW-88T7-13823-TE-T UL LISTED NO.: 6OF5 RINGER EQUIVALENCY: 0.7A TYPE JACK: RJ11C PROGRAM VERSION: ADI 2.01 CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 10: Fcc Notice
FCC registration number and ringer equivalence number. These numbers are listed in section 7.0 The FCC further requires that you notify your local telephone company when permanently disconnecting this telephone. CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 11: Parts List
MICROSWITCH ASSY. 705-110 CONNECTORIZED KEYPAD 700-008 KEYPAD CABLE 301-030 INSTRUCTION CARD KIT 301-009 NETWORK 301-004 HANDSET, ARMORED CORD 301-012 OUTER COVER LOCK SCREW 308-015 HANDSET SWIVEL 650-541 MCRK-2 PCB ASSEMBLY ACCESSORIES: 301-037 SECURITY TOOL CEECO Communication Equipment & Engineering Company PROPRIETARY... -
Page 12: Repair And Return Information
Plantation, FL 33313 (305) 587-5430 10.3 NON-WARRANTY REPAIR CEECO will repair equipment out of warranty for a set charge plus parts. The customer must pay the shipping costs both directions. 10.4 RETURN FOR CREDIT Material may be returned for credit only with prior approval. Material authorized for return is subject to a 15% restocking charge based on the manufacturer’s list price. -
Page 13: Warranty Policy
This warranty is limited to the value of material only. CEECO will repair or replace any unit during this period if found to be defective for reasons other than abuse and improper use or improper installation. -
Page 14: Diagram
When programming is completed, move the mini jumpers to the OFF position. NOTE: Sold by: Do not leave the mini jumpers in the ON position; this will decrease battery life. http://www.TWAcomm.com Toll Free: (877) 892-2666 CEECO Communication Equipment & Engineering Company PROPRIETARY...
Need help?
Do you have a question about the SSC-303-D and is the answer not in the manual?
Questions and answers