BT Fax User Manual page 47

The power save feature reduces power consumption
from 6W to 2W while your PaperJet 300 is lying idle.
Power save is switched off when you receive your
machine.
You can switch power save on and off by changing
the feature setting 13, see list on page 42. The power
save setting will switch on about 5 minutes after the
last button has been pressed or the last call was
received. The display shows
Power save will automatically switch off again, when
a button is pressed, the handset is lifted or a new
call is received.
Power save mode does not switch on if the display
shows or if you have a colour cartridge
installed.
If you have connected your PaperJet 300 to a
computer and it has gone into power save mode,
you will not be able to print until power save is
deactivated. You can only deactivate power save by
pressing a button on your PaperJet 300 or by lifting
the handset. Power save cannot be deactivated
through a command from your computer.
If someone is trying to send you a fax that
is longer than the paper you are printing on,
your PaperJet 300 will try to receive it over
2 pages. You can reduce the printing area in
order to compress the fax onto a single page.
All faxes are reduced. Your PaperJet 300
has been originally set to 90% of the original
.
size, but incoming faxes can be switched
between 90%, 84% or 70%. You must re-set
the reduction again to change it back.
Press
Press
Display shows
Press
Press
Press Function until display shows
Press
Set the ratio you want
00 = 90%
01 = 84%
02 = 70%
Press
Press
ECM automatically reduces the possibility of
damaged data when sending or receiving faxes.
ECM is switched on and we recommend that you
do not change this setting.
until the display shows
.
until the display shows
.
(or enter , to go straight there).
.
to confirm.
to return to standby.
45