Client - D-Link DIR-300NRU User Manual

DIR-300NRU Wireless Router with Built-in 4-port Switch
User Manual

Client

On the Wi-Fi / Client page, you can configure the router as a client to connect to a wireless access
point.
As a rule, the client mode is used to connect to a WISP network. All parameters specified on this
page should be provided by your WISP.
To configure the router as a client, select the Enable client checkbox. When the checkbox is
selected, the following fields are displayed on the page:
Parameter
SSID
BSSID
Network Authentication The authentication type of the network to which the router connects.
When the Open or Shared authentication type is selected, the following fields are available:
Parameter
Enable Encryption WEP
Figure 102. The page for configuring the client mode.
The name of the network to which the router connects.
The unique identifier of the network to which the router connects.
The checkbox activating WEP encryption. When the checkbox is
selected, the Default Key ID field and four Encryption Key
WEP fields are displayed on the page. For the
authentication type the checkbox is always selected.
Page 131 of 172
Configuring via Web-based Interface
Description
Description
Shared