Troubleshooting - Jura GIGA X3C Operating & Cleaning Instructions

Troubleshooting:

Milk flow
No milk Spluttering milk
Solution:
1. Remove the splash guard.
2. Press the black releasing buttons on the sides of the spout cover and lift the cover off.
3. If the flat milk is flowing normally and the problem is with the froth milk only, replace the air suction
cover and test the milk again. If the problem has been solved, purchase spare air suction (Part no. 70008). If the
problem has not been solved go to step 4.
4. Remove the auto frother by pulling the milk outlet down
will be able to remove the auto frother by pulling it towards you
5. Separate the auto frother into 6 parts
6. Soak 6 parts (Fig 8)
7. Remove the parts from the solution and rinse under tap water.
8. Clean the milk, air and steam paths using the cleaning brushes. See 2 x milk path holes in Fig
9. Pour tap water into the top of the milk outlet
another 30 min and retest. If you are not able to clean the outlet, order in another outlet. (Part no. 70007)
10. Re-assemble the auto frother ensuring that the arrow tips line up.
11. Refit the auto frother, cover, splash guard and test. If the problem has not been solved ph 1300 365 487.
Figure 1
Figure 6
Figure 11 (Milk path)
Not filling cups
(Fig 1)
(Fig 8).
in 250ml of warm water and 15 ml of Cafetto red weekly cleaning solution (71145) for 30 min.
Figure 2
Figure 7
Figure 12 (Air path)
Froth milk is flat
(Fig 5) and pulling the milk hose connector out
(Fig 7).
(Fig 14). If water does not pour from the two outlets as shown, soak it for
(Fig 15)
Figure 3
Figure 8
Figure 13 (Steam path)
(Fig 2 – 3)
Figure 4
Figure 9 (Milk path)
Figure 14 (Test outlet)
(Fig 4), refit the
(Fig 6). Now you
11.(Fig 9 – 13)
Figure 5
Figure 10 (Milk path)
Figure 15