Auto Run Mode; Setting Maximum Tilt Angles; Setting Reversed Or Normal Pan; Setting Reversed Or Normal Tilt - Beamz MHL 108 WASH 150.509 Instruction Manual

Setting Maximum Tilt Angles

To select, use the "MODE/ESC" button and choose "t.9" or "t.18" "UP" and "DOWN" buttons cycle
between all available Tilt Angles. Press the "ENTER" button to confirm the chosen selection.
LED Display
t.9
t.18
1-Built-in Program Mode (continued)
As the unit can be mounted hung under earth trussing, or can sit equally well on a flat surface, pan,
tilt and LED display settings can be reserved to provide correct coverage and ease of use.

Setting Reversed or Normal Pan

To select, use the "MODE/ESC" button and choose "Pan"(normal) or "r Pan" (reversed). "UP" and
"DOWN" buttons cycle between the two settings. Press the "ENTER" button to confirm the chosen
selection

Setting Reversed or Normal Tilt

To select, use the "MODE/ESC" button and choose "t.L" (normal) or "r tilt"(reversed)."UP" and
"DOWN" buttons cycle between the two settings. Press the "ENTER" button to confirm the chosen
selection
Setting Reversed or Normal LED Display
To select, use the "MODE/ESC" button and choose "d.s"(normal) or "rd.s"(reversed). "UP" and
"DOWN" buttons cycle between the two settings. Press the "ENTER" button to confirm the chosen
selection

2-Auto Run Mode

One of two Auto Run Sub-modes can be selected with a choice of preset speeds .This mode enables
the unit to act as a Master to other Slave units
Choosing Auto Run Sub-modes
To select, use the "MODE/ESC" button to show "NAFA" or "NASL". "UP" and "DOWN" buttons
change between the two initial options. With the appropriated option selected, use "ENTER" to
confirm and the LED Display with change to: "Fast" (fast) or "SloU" (slow). The unit will then run at the
chosen speed
Initial LED Display
NAFA
NAFL
3-Sound Activated Mode
The unit responds to sounds picked up by the unit in microphone to create a light show . Each sound
picked up makes changes to color shown and position of the effects. This mode enables the unit to act
a Master to other Slave units
Choosing Sound Activated:
To select, use the "MODE/ESC" button and choose "NStS". When the "ENTER" button is pressed the
LED Display changes to "SrUn" and the unit enters Sound Activated Mode.
Initial LED Display
NStS
Maximum Tilt
90º
180º
Second LED Display
Fast
SloU
Second LED Display
SrUn
- 7 -
Sub-mode
Fast Auto Run
Slow Auto Run
Sub-mode
Sound Activated