Power Supply; How To Control The Unit; Master/Slave Mode - Beamz Multi Acis III LED Instruction Manual

POWERSUPPLY
On the label on the backside of the light effect is indicated on this type of power supply must be connected. Check that the
mains voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The light
effect must also be directly connected to the mains and may be used. No dimmer or adjustable power supply

HOW TO CONTROL THE UNIT

Three ways to operation:
A.

Master/Slave mode

B. Sound active and Auto mode
C. DMX controller
MODE MENU
DMX MODE
(ch. 1-512)
AUTO MODE
(program 1 – 7)
(speed 1 – 9)
SOUND MODE
(program 1 – 7)
(speed 1 – 9)
A. MASTER- /SLAVE MODE
The unit can be linked together in daisy chain in master/slave mode to perform the great built-in pre-programmed lighting
shows triggered by music. In Master/Slave mode refer to the settings below:
Master unit: Set working at Easy sound or auto mode operation
Slave units: DMX start address MUST be set to d001.
Power 230Vac
DMX In
UP - DOWN
Max. 6 Units