Telephone Line Connections; Pgm Connections - Magellan MG-6060 Programming Manual

Telephone Line Connections

Back view of the Magellan console.
To connect the telephone line
directly to the console:
1. Connect a RJ31X to the -1,
R
1, and terminals as
RING TIP
shown at right.
2. Connect the telephone
company wires and the home
telephone to the RJ31X.
Back view of the
Magellan console.
Do not connect
the RJ-11 cable
into this plug.
To connect the telephone line directly to the console:
1. Insert one end of the 4-pin RJ-11 cable into the line plug of the Magellan console.
2. Insert the other end of the RJ-11 cable into a standard telephone wall plug.

PGM Connections

Method 2
External
relay
External
DC Power
Supply
Magellan
Figure 5: Telephone Line Direct Connect
-
T
Figure 6: Line Plug Connection
Devices
such as a
(> 100mA)
light, etc.
If the PGM current consumption is less than 100mA, use
method 1. If the PGM current consumption is to exceed
100mA, use method 2.
Figure 7: PGM Connections
Back view of the
Magellan console.
Telephone Line Connection Note
The Magellan console must be able to seize the telephone line and place a
call in an emergency situation. It must be able to do this even if other
equipment (telephones, answering machines, computer modems, etc.)
already has the line in use. To do so, the Magellan console must be
connected to a properly installed RJ31X (or RJ38X) jack that is electrically
in series with and ahead of all other equipment attached to the same
telephone line. Proper installation is depicted in the diagram below. If you
have any questions concerning these instructions, you should consult your
telephone company or a qualified installer about installing the RJ31X (or
RJ38X) jack and the Magellan console for you.
Do not exceed 24Vdc when connecting
the PGM outputs.
Method 1
(
< 100mA
External
DC Power
Supply
)
Devices
such as a
light, etc.
17