Tabletop Mounting; Mounting Magellan On The Wall - Magellan MG-6060 Programming Manual

Tabletop Mounting

Mounting Magellan on the Wall

B
A (x7)
C
Magellan
Figure 14: Tabletop Mounting
Back view of the
Magellan console.
Wall plate
Tabletop
Figure 15: Mounting Magellan onto the Wall Plate
Plastic feet (x2)
Rubber stops (x2)
Tabletop mounting may not be an approved installation method by local regulations. It is
recommended that the local regulations be verified prior to installing the Magellan
console using this method.
To mount the wall plate:
1. Place the wall plate on the desired spot of the wall.
2. Drill and insert the screws into the holes labeled A at left.
To mount the Magellan console:
1. Place the console back plate flush against the mounted wall plate.
2. Slide the Magellan's open slots labeled D (see Inset 1 below) onto the wall plate's tabs labeled B.
3. Gently apply downward pressure to insert the wall plate's tabs into Magellan's open slots.
4. Insert two screws through the wall plate's screw holes labeled C and into Magellan's back plate
screw holes labeled E (see Inset 1 below). This will secure the console to the wall.
D
To mount the Magellan console on a tabletop
the wall plate has to be inserted beforehand:
1. Slide the wall plate's tabs labeled B into the
Magellan console's open slots labeled D
(see Figure 15 on page 21).
2. Insert two screws (included) through the wall
plate's screw holes labeled C into holes
labeled E in the Magellan console (see
Figure 15 on page 21).
3. Insert the two plastic feet (included) into the
appropriate holes on the back plate of the
Magellan console as shown at left.
4. Attach the two rubber stops (included) to the
lower edge of the wall plate as shown at left.
The plastic feet are used to raise the
Magellan console to a slight angle for
easy viewing while the rubber stops
prevent the console from sliding when
Magellan is being used.
Inset 1: Magellan's Backplate
E
D
21