Table of Contents
Advertisement
In the event of an emergency situation or to attract attention to your vehicle, press and hold button (I) on the transmitter
for about (5) seconds. The Siren will sound and lights will flash. Press button (I) again to reset.
SHOCK SENSOR BYPASS THROUGH REMOTE
To bypass shock sensor protection, Press Button (I) to arm system, then within 3 seconds press button (II).
VALET MODE:
To disable the Alarm and Remote Start sections of the system while still allowing door lock/unlock, turn the ignition ON
and press the override/program button until the dash LED turns on solid and one siren chirp is heard (about 5 seconds).
Repeat the process to exit valet mode (LED will turn off, lights flash twice, and chirps twice).
OPERATION
EMERGENCY OVERRIDE:
If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to perform an
emergency override to disarm the system. Open the door with the key, (alarm will sound) turn the Ignition ON, and
press and hold the override/program button about 3 seconds. The Alarm will disarm and enter the Valet mode to allow
you to use the vehicle. You can repair/replace the pager/remote or see your installing dealer for assistance.
TRUNK POP/AUXILIARY FEATURE: (Optional)
To pop the trunk or activate an auxiliary feature, press button (III) on the transmitter for about 1½ seconds until it beeps.
Trunk pop feature is recommended for vehicles equipped with a Factory Electric trunk release. Extra parts and/or labor
may be necessary for this feature. If the system is armed, pressing button (III) may or may not trigger the alarm
system when opening the trunk depending on programming option #10 configuration.
AUTOLOCK/UNLOCK WITH IGNITION: (Programmable)
The doors will automatically lock when the ignition is turned on and will unlock when the ignition is turned off. If a door
is open the unit will not lock to prevent keys from being locked in.
PASSIVE ARMING / PASSIVE LOCK MODES:
If programmed for passive (Automatic) Arming, the system will Arm itself 30 Seconds after the ignition is turned off and
the last door has been closed. The LED will begin flashing rapidly while counting down to Passively Arm. If a door is
open or reopened during the countdown, the system will wait (LED solid) for the door or zone to close before arming.
The unit will chirp once and flash the lights once. If Passive Locks are programmed ON, then doors will lock also.
Note: Passive Arming may qualify for insurance discounts-check with your agent or proprietor. Passive
locking may increase the chance of locking the keys inside the vehicle.
ACTIVE RE-ARMING:
Active Re-arming allows the system to re-arm itself 30 seconds after it is disarmed with the transmitter in the event that
a door has not been opened. This is handy if the vehicle is accidentally disarmed without your knowledge (Remote is
pressed while in your pocket/purse). This feature can be turned off with the programming options.
Advertisement
Table of Contents
