Table of Contents
Advertisement
Electrical Installation
For your safety please read the following information:
WARNING! Before effecting any intervention on the electrical parts the appliance must be disconnected
from the network.
IMPORTANT: The oven must be installed in accordance with the manufacturer's instructions. Incorrect
installation, for which the manufacturer accepts no responsibility, may cause damage to persons,
animals and things.
General
– The connection to the electrical network must be carried out by qualified personnel and must be according
to existing norms.
– The appliance must be connected to the electrical network verifying above all that the voltage corresponds
to the value indicated on the specifications plate and that the cables section of the electrical plant can bear
the load which is also indicated on the plate.
– The appliance can be connected directly to the mains placing an omnipolar switch with minimum opening
between the contacts of 3 mm between the appliance and the mains.
– The power supply cable must not touch the hot parts and must be positioned so that it does not exceed
75°C at any point.
– Once the appliance has been installed, the switch must always be accessible.
– If the power supply cable is damaged it must be substituted by a suitable cable.
IMPORTANT: this double oven must be connected to a suitable double pole control unit adjacent to the
oven.
NO DIVERSITY CAN BE APPLIED TO THIS CONTROL UNIT.
Feeder Cable Section
Type H05RR-F or H05VV-F
230 V~
3 x 2.5 mm
2
(**) – Connection to wall-mounting distribution panel.
(**)
The connection of
the appliance to the
grounding unit is
mandatory.
The manufacturer
declines every
responsability for
any inconvenience
resulting from the
inobservance of this
condition.
29
Advertisement
Table of Contents
