CDA DK951 Series Installation, Use And Maintenance Manual page 21

Built-in double oven
Table of Contents

Advertisement

Replacing the Halogen Oven Lights
WARNING: Ensure the appliance is switched off before replacing the
lamp to avoid the possibility of electric shock.
Allow the oven cavity and the heating elements to cool down.
Switch off the electrical supply.
Top Right Lamp:
Remove the protective cover C (fig. 7);
Replace the halogen lamp B with a new one suitable for high tem-
peratures having the following specifications: 230V and same power
(check watt power as stamped in the lamp itself ) of the replaced
lamp.

IMPORTANT WARNING: Never replace the bulb with bare hands;
contamination from your fingers can cause premature failure.

Always use a clean cloth or gloves.
Refit the protective cover;
Left Lamp (Lower Main Oven only):
Remove the left wire rack by unscrewing the fixing screws.

Press down from the top the protective cover A (fig. 7) and remove it
by rotating on the lower side. IMPORTANT: never use screwdrivers
or other utensils to remove the cover A. This could damage the ena-
mel of the oven or the lampholder. Operate only by hands.
Replace the halogen lamp B with a new one suitable for high tem-
peratures having the following specifications: 230V and same power
(check watt power as stamped in the lamp itself ) of the replaced
lamp.

IMPORTANT WARNING: Never replace the bulb with bare hands;
contamination from your fingers can cause premature failure.

Always use a clean cloth or gloves.
Refit the protective cover A operating in reverse order.

ATTENTION: the notch in the inner edge of the cover must be orien-
ted toward the lamp.
Assemble the left wire rack.
Note: Oven bulb replacement is not covered by your guarantee.
1
A
Fig. 7
2
A
WRONG
CORRECT
A
B
C
B
21

Advertisement

Table of Contents
loading

Table of Contents