Table of Contents
Advertisement
CS-2002DC PROGRAMMABLE OPTIONS
1. Turn the Ignition ON and press the Override/Program button 5 times. You should hear 6 confirmation chirps.
2. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to
the feature list below. The siren will chirp for each button press. DO NOT LOSE COUNT!!
3. When you get to the desired option number, press buttons #1, #2, or #3 (Lock, Unlock, Trunk) on the transmitter to
change the option. Button 1 gives a single light flash, Button 2 gives two light flashes, and Button 3 gives three light
flashes. See chart Below for Option descriptions and vales.
4. Change ONE option at a time repeating steps 1-3 as needed. When you are finished customizing options, check
operation to see if the option(s) have changed.
Option # Option Description
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
1. PASSIVE ARMING
This option controls the Passive (Automatic) Arming feature. If ON, arming will occur 30 Seconds after the ignition is
turned off and the last door has been closed. The LED will begin flashing rapidly while counting down. If a door is
reopened, the system will wait (LED solid) for the door or zone to close before arming. The unit will chirp once and
flash the lights once. Doors will lock if passive locking is selected. Factory default setting is ON.
OPTION PROGRAMMING
PROGRAMMING OPTIONS CHART
Passive Arming
Quiet Chirp Arm/Disarm
with Button #3
Lights on with disarm
Active Re-Arm
Silent Arm/Disarm
Disarm with trunk pop
Ignition controlled Locks
Door Lock Pulse Time
Carjack Enable/Disable
Lock with passive arm
Double Unlock Pulse
Type of Carjack Protection
10/60 Sec. Door Open
Warning
Horn Chirps
BUTTON 1
BUTTON 2
LOCK
UNLOCK
(Default)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
ON
ON
OFF
0.7 Sec.
3 Sec.
DISABLE
ENABLE
ON
OFF
OFF
ON
ACTIVE
PASSIVE
10 Sec.
60 Sec.
OFF
Arm/Disarm
Only
BUTTON 3
TRUNK
FULL-TIME
Arm/Disarm/
Pre-Warning
Advertisement
Table of Contents
