Installing The First Projector (Set A); Preparing Elevator Feet; Deciding Installation Position - Hitachi CP-WU5500 User Manual

2.2 Installing the fi rst projector (Set A)

Preparing elevator feet

When stacking the two projectors, set the length of the
elevator feet to the minimum using the elevator buttons
on Set A and B.
CAUTION ► Be careful when stacking the two
projectors, the projector on top may slide down.

Deciding installation position

Decide the position of Set A and its projection angle.
→ Adjusting the projector's
WARNING ►It is possible to install the projector for any direction with specifi ed
mounting accessories. Consult with your dealer about such a special installation.
• Set the tilt angle of Set A to within 11 degrees from the level line.
NOTE
• Take the followings into account when considering the installation position.
- VERTICAL adjuster should be set to the upper limit position.
- ZOOM ring should not be set to the widest position.
- HORIZONTAL adjuster is recommended to be set near the center position.
elevator)
Installation
(User's Manual (concise)
7