For Simple Stack Users - Hitachi CP-WU5500 User Manual

Installation

For Simple Stack users

1.
Press the MENU button on the remote control to display the menu on Set A.
2.
Use the ▲/▼/◄/► buttons to open the TEMPLATE
dialog, then select STACK on the dialog.
(Operating Guide
3.
Press the MENU button on the control panel of
Set B to display the menu.
4.
Use the ▲/▼/◄/► buttons to select PERFECT
FIT from EASY MENU, or the SETUP menu of
ADVANCED MENU.
MENU or SETUP
PERFECT FIT dialog appears on screen.
Set PATTERN settings to ON to display the test
pattern.
5.
Using PERFECT FIT on Set B, adjust the image size
and position of Set B to superimpose well to the
image of Set A. It is recommended to adjust in the
following ways.
(1) Roughly adjust the four corners in the order below.
Top left → Top right → Bottom right → Bottom left
(2) Fine adjust the four corners in the same way.
NOTES for all users
or
EASY MENU
• It is strongly recommended to use a flat screen. If a curved or skewed screen
is used, it is very difficult to align the two images even if you use the pin/barrel
adjustment of PERFECT FIT.
• Even through fine adjustment of the images from the two projectors, it may
not be possible to superimpose the images well enough depending on the input
signals. In this case, try the following methods.
- Press the AUTO button on the remote control or execute AUTO ADJUST
EXECUTE (Operating Guide
- Adjust H POSITION and V POSITION
on each of the projectors.
- Check the RESOLUTION setting in the INPUT menu, and change to the same
setting if the setting differs between Main and Sub.
INPUT menu)
16
→
SCREEN
(Operating Guide
menu)
• For details on PERFECT FIT, refer to
in the
SETUP menu
menu)
→
EASY
Operating Guide.
→ IMAGE menu) on each of the projectors.
(Operating Guide
STACK of TEMPLATE
PERFECT FIT dialog
on STACK of TEMPLATE
PERFECT FIT
→ IMAGE
(Operating Guide
of
menu)
→