Stack Menu Settings; Displaying Stack Menu - Hitachi CP-WU5500 User Manual

3. STACK menu settings

Set the Intellectual Stack operation using the STACK menu.
NOTE • If you are using Simple Stack without RS-232C connection, skip this
chapter.
• If you do not need to change the settings made during the installation
explained prior to this chapter, go to
• Read 3.7 Important information for Intellectual Stack

3.1 Displaying STACK menu

Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION > STACK
STACK menu will appear on screen.
(Operating Guide
The setting for Intellectual Stack operation starts from this menu.
• Check that the following settings are made on both projectors.
NOTE
Otherwise, STACK menu on the projectors cannot be operated. ( 6 )
- STANDBY MODE in SETUP menu: NORMAL
(Operating Guide
- COMMUNICATION TYPE under COMMUNICATION in SERVICE menu: OFF
(Operating Guide
- STACK LOCK in SECURITY menu: OFF ( 6 )
→ OPTION menu)
→
SETUP menu)
→ OPTION menu)
3.3 Selecting lamp operation mode. ( 19 )
carefully. ( 25 )
17