Installing The Second Projector (Set B); Stacking The Projectors - Hitachi CP-WU5500 User Manual

Installation

2.3 Installing the second projector (Set B)

Stacking the projectors

1. Place Set B on Set A when stacking the
two projectors. Make sure the heel on the bottom
of Set B is inserted into the corresponding
pocket on the top of Set A.
2. With Set B placed on Set A, push the
elevator buttons of Set B to extend the
elevator feet without lifting Set B. Make
sure the elevator feet reach the bottom of
the stack pockets on Set A.
CAUTION ► Be careful when stacking the
two projectors, the projector on top may slide
down.
• If Set B is tilt further, the image of Set B may not be superimposed to
NOTE
the image of Set A.
• If the elevator feet of Set A are used, make sure the tilt angle for both sets is
within 11 degrees from the level line.
(continued on next page)
10