Installation
2.2 Installing the first projector (Set A)
Setting up Set A
1.
Turn on Set A.
2.
Set the lens position to the upper limit with the VERTICAL adjuster.
• If it is not set to the upper limit, the image of Set B may not
NOTE
superimpose well enough to the image of Set A.
• Perform the INSTALLATION setting first if necessary as it may change the
image position.
• HORIZONTAL adjuster is recommended to be set near the center position.
3.
Adjust the image of Set A to fit the screen with the VERTICAL adjuster,
HORIZONTAL adjuster, ZOOM ring and FOCUS ring.
→
Displaying the
Adjust the image position using KEYSTONE and PERFECT FIT if necessary.
(Operating Guide
• Do not adjust ZOOM ring to the widest position, otherwise the
NOTE
image of Set B may not superimpose well enough to the image of Set A. Fine
adjusting the image position of Set B electrically does not increase its image
size. Use the ZOOM ring to adjust the image size of Set B to slightly larger
than Set A.
• KEYSTONE, PERFECT FIT, or WARPING function cannot be used at the
same time. Please use an appropriate function.
• If you are using Simple Stack, go to
B). ( 10 )
(Set
(continued on next page)
8
(Operating Guide
picture)
→
EASY MENU
→
SETUP
menu)
(User's Manual (concise)
or
SETUP
menu)
2.3 Installation of the second projector