Connecting Signal Cables; Inputting Image From Main To Sub - Hitachi CP-WU5500 User Manual

4.2 Connecting signal cables

There are two methods to input image to the Sub projector. ( 22, 23 )
- Inputting image from the MONITOR OUT (HDMI OUT) port on Main to Sub.
- Inputting image to Sub and Main individually.

Inputting image from Main to Sub

Using MONITOR OUT port
1.
Connect the MONITOR OUT port on Main to the COMPUTER IN port on Sub
with a computer cable.
2.
Connect the image output device to COMPUTER IN port on Main.
NOTES for Intellectual Stack
• COMPUTER IN can be used as the input
port for the Main projector in Intellectual Stack.
Do not use other ports for image input.
- You can input component signals to
COMPUTER IN.
- You can input video signals to the Y pin of
the component video of COMPUTER IN.
NOTES for Simple Stack
• COMPUTER IN can be used as the input
port for the projector that is connected with
a computer cable at its MONITOR OUT port.
If you wish to use other input ports, input the
image to Sub and Main individually.
(continued on next page)
Connecting cables
Main
Sub
29