Table of Contents
Advertisement
Crestron STX-1700C
Operations Guide - DOC. 6226A
Accessing the "Port Settings" Window
7. Select the RS-232 connection type. Verify the available COM is
selected. Verify that the baud rate is set to 115200 (PRO2 default), the
parity is None, the data bits is Eight, the stop bits is One, XON/XOFF
is not selected, and RTS/CTS is selected. Click the OK button to save
the settings and close the window.
NOTE: If problems occur when transferring any Cresnet file (touchpanel
project/firmware), lower the port speed baud rate to 38400 to match the Cresnet bus
speed when transferring through a control system. Make sure XModem is selected
from Mode for Network Transfers.
"Port Settings" Window
8. Proceed to "Uploading a VT Pro-e Project" on the next page, or to
"Firmware Upgrade" that begins on page 25 as appropriate.
2-Way RF Wireless Touchpanel
2-Way RF Wireless Touchpanel: STX-1700C • 23
Advertisement
Table of Contents
