Table of Contents
Advertisement
2-Way RF Wireless Touchpanel
KEY CLICK SETUP
SCREEN SETTINGS -
BRIGHTNESS
STARTUP PREFERENCE
10 • 2-Way RF Wireless Touchpanel: STX-1700C
decrease the most significant digit by one, respectively (i.e., 1, 2, 3, ...F). Refer to
the latest revision of the STRFGWX Operation Guide (Doc. 5811) for more
information on setting up the RF Channel for the RF gateway.
NOTE: The RF TEST MENU button should only be used under supervision from
a Crestron customer service representative during telephone support.
After the Cresnet ID, RF ID and RF Channel settings have been verified, touch the
Return button at the bottom of the screen to save settings and display the SELECT
INTERFACE screen.
Key Click Setup
From the SETUP MENU, press the Key Click Enabled button to open KEY CLICK
SETUP screen. (If the function is currently disabled, the button legend is "Key Click
Disabled.") To enable an audible tone (beep) when the touchpanel buttons are
pressed, select among the Short, Med, or Long KEY CLICK ENABLE/LEN
buttons to set the duration of the tone. The touchpanel responds with a corresponding
signal. To disable the feature, select Click Off.
Use the KEY CLICK VOLUME UP and DOWN buttons to increase and decrease
the volume of the signal. The area to the right of the buttons shows the relative
volume from 0% to 100%, both as a numeric value and, for a quick visual reference,
as an analog bar.
Select the Return button to return to the SETUP MENU.
Brightness
From the SETUP MENU, press the Brightness button to open the SCREEN
SETTINGS – BRIGHTNESS screen. The UP and DOWN buttons increase and
decrease screen brightness, respectively. The area to the right of the buttons shows
the relative brightness from 0% to 100%.
Select the Return button to return to the SETUP MENU.
Startup Preference
NOTE: This feature applies only to units with the optional pushbuttons installed.
Refer to "Appendix B: Installation of Optional Pushbuttons" for details.
The Startup Preference option allows (when the touchpanel is off or in standby) the
display to come on or stay off when a "quick" pushbutton is pressed. From the
SETUP MENU, press the Startup Preference button to open the STARTUP
PREFERENCE screen.
When pressed, the DISPLAY ON FROM HARDKEY button toggles between
ENABLED and DISABLED. With ENABLED selected, the display comes on when
one of the "quick" pushbuttons is pressed. With DISABLED selected, the display
stays off when a "quick" pushbutton is pressed (if touchpanel was off, it goes to
standby). The default is DISABLED.
Select the Return button to return to the SETUP MENU.
Crestron STX-1700C
Operations Guide - DOC. 6226A
Advertisement
Table of Contents
