Network Print Software Installation Problems - Oce cx2100 User Manual

®
Windows Vista users:
a
Click the Start button, Control Panel, Network and Internet, Windows Firewall and click Change
settings.
b
When the User Account Control screen appears, do the following.
Users who have administrator rights: Click Continue.
For users who do not have administrator rights: Enter the administrator password and click OK.
c
Click the General tab. Make sure that Off (not recommended) is selected.
d
Click OK.
Note
After the Océ software package is installed, enable again your Firewall.
®
For Macintosh
Re-select your machine in the DeviceSelector application located in Mac OS X or Macintosh HD (Startup
Disk)/Library/Printers/Oce/Utilities or from the model pull-down list of ControlCenter3.

Network print software installation problems

The Océ print server is not found during the setup of the network print software or from the
installation of the printer driver of the cx2100 in Windows
The Océ print server is not found using the Simple Network Configuration capabilities of Mac OS
Make sure you have completed the IP address setting of the Océ print server according to Chapter 2 of this
User's Guide before installing the network print software or printer driver.
For a network with an Ethernet cable connection
Make sure you have completed the IP address setting of the Océ print server according to Chapter 2 of
this User's Guide before installing the network print software or printer driver.
For a wireless network
Make sure you have completed the IP address setting and wireless network settings of the Océ print server
according to Chapter 3 of this User's Guide before installing the network print software or printer driver.
Check the following:
a
Make sure that the machine is powered on, is on-line and ready to print.
b
(For wired network) Check to see if there is any LED activity. Océ print servers have two LEDs on the
back panel of the machine. The upper green LED shows Link/Activity (Received/Transmit) status. The
lower orange LED shows Speed status.
No light: If the upper LED is off, then the print server is not connected to the network.
The upper LED is green: The Link/Activity LED will be green if the print server is connected to a
Ethernet network.
®
.
Troubleshooting
15
15
®
X.
15
15
161