Panasonic CF-W4 Series Reference Manual page 157

Problems with Starting Up, Shutting Down, and Standby and
Hibernation Mode
To log on with an Administrator user account
Cannot boot from a floppy disk
[Executing Battery Recalibration] screen is displayed
"Remove disks or other media. Press any key to restart" is
displayed
For how to make the change, refer to "SD Memory Card Security Function" (
and "Set the Windows Log on Password" (
If you create a user account after Windows setup, the Administrator account used during
Windows setup does not appear on the log on screen.
To log on with the Administrator account, in the log on screen, press the Ctrl +Alt +Del
key twice, enter "Administrator" in [User name], and enter the password if one is set, then
click [OK].
Check if there is a Panasonic external floppy disk drive connected (CF-VFDU03). It is not
possible to boot from other floppy disk drives.
Check that the boot disk is correctly inserted.
Run the Setup Utility, and confirm the following settings.
• [Legacy USB Support] is set to [Enable] in the [Advanced] menu. (
• [USB FDD] is the first device shown in [Boot priority order] in the [Boot] menu. (
147)
Turn off the computer, and reconnect the external floppy disk drive.
When Windows is shut down during the Battery Recalibration procedure, if you select
[Cancel] in the [End Program] screen, Windows shutdown is aborted. In this case, Battery
Recalibration will begin the next time the computer is started. To start up Windows, turn
off the computer by sliding the power switch, and then turn it back on again.
Check whether a floppy disk not allowing system booting is inserted in the floppy disk
drive. If it is inserted, remove, then press any key.
If a USB device is connected, remove the USB device, or set [Legacy USB Support] to
[Disable] in the [Advanced] menu of the Setup Utility. (
157
page 58).
page 144)
page 102)
page 144)
page