Stacking; Hardware Hookup - Crestron CNX-BIPAD8 Operation Manual

Professional Audio Distribution Processor
10 • Professional Audio Distribution Processor: CNX-BIPAD8
below to attach ears to the CNX-BIPAD8. The only tool required for this procedure
is a #2 Phillips screwdriver.
1. There are 16 screws that secure the CNX-BIPAD8 top cover. Remove
the three screws closest to the front panel from one side of the unit.
2. Position a rack ear so that its drilled holes align with the holes vacated
by the screws in step 1.
3. Secure the ear to the CNX-BIPAD8 with the three screws from step 1,
as shown below.
Ear Attachment for Rack Mounting (Side View of Unit)
4. Tighten screws to finger-tight, then, using a #2 Phillips screwdriver,
tighten an additional 1/8-turn.
5. Repeat procedure (steps 1 and 2) to attach ear to the other side.
6. If the rear panel of the CNX-BIPAD8 is accessible when mounted in
the rack, install the CNX-BIPAD8. If the rear panel is NOT accessible,
perform the hookup procedure before rack installation.

Stacking

Four "feet" are provided with the CNX-BIPAD8 so that if the unit is not rack
mounted, the rubber feet can provide stability when the unit is placed on a flat
surface or stacked. These feet should be attached prior to the hookup procedure.
Refer to the illustration below for placement of the feet.
Feet Location (Bottom View of Unit)

Hardware Hookup

Refer to the hookup diagram after this paragraph. Other than making the power
connection last, complete the connections in any order.
NOTE: Refer to "Network Wiring" on page 7 when making connections to the port
labeled NET.
Crestron CNX-BIPAD8
FASTEN WITH THREE
TOP COVER SCREWS
ATTACH FEET
NEAR CORNERS
OF THE UNIT
Operations Guide - DOC. 8160A