Goddess RSD 0124 GW8F Instruction Manual page 50

EN
Install door external handle (if external handle is present)
Levelling the unit
à To do this adjust the two levelling feet at front of the
unit.
à If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
Note: Above pictures are for reference only.
Positioning
Install this appliance at a location where the ambient temperature corresponds
to the climate class indicated on the rating plate of the appliance. For refrigerating
appliances with climate class:
- extended temperate: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 10 °C to 32 °C (SN)
- temperate: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 32 °C (N)
- subtropical: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 38 °C (ST)
- tropical: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 43 °C (T)
Location
The appliance should be installed well away from sources of heat such as radiators,
boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is positioned below an overhanging
wall unit, the minimum distance between the top of the cabi-net and the wall unit must
be at least 100 mm. Ideally, however, the appliance should not be positioned below
overhanging wall units. Accurate leveling is ensured by one or more adjust-able feet
at the base of the cabinet. This refrigerating appliance is not intended to be used as
a built-in appliance.
It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
915 mm
WARNING!
EN - 50