Method B (Touch Settable Ids) - Crestron C2N-RTHS Operations & Installation Manual

Crestron C2N-RTHS

Method B (Touch Settable IDs)

Touch Settable ID (TSID) modes are supported through the use of the
pinhole setup button and a red LED. These procedures are for TSID-
enabled network devices during the initial configuration of a Cresnet
system or when such devices are being added/replaced. Before using this
method, you should have a list of all current network devices and their Net
IDs, to avoid assigning duplicate IDs.
Operations & Installation Guide - DOC. 6232A
10. Repeat this procedure for each C2N-RTHS to be added to the
system.
1. Ensure that all C2N-RTHS are connected to the control
system.
2. Open the Crestron Viewport version 3.35 or later.
3. From the Viewport menu, select Functions | Assign Cresnet
ID by Serial Number. The "Set Net ID by TSID" window
appears. The window is first displayed with the data fields
empty. (Refer to the following figure.)
"Set Net ID by TSID" Window
4. Click on the Search for Touch Settable Devices button. The
system searches the network and lists all TSID-enabled devices
Remote Temperature/Humidity Sensor
Remote Temperature/Humidity Sensor • 9