Elite EliteTIG AC/DC 225 User Manual page 65

The parameters for the pulsed TIG (AC and DC) are:
Pulsed TIG peak current : It is the maximum current level at which the
pulsed wave rises.
Pulsed TIG ratio : It is the percentage of the total pulsed wave in which
the machine delivers the peak current .
Pulsed TIG base current : It is the minimum current level at which the
pulsed wave decreases.
Pulsed TIG frequency : Configurable from 0 to 999 Hz. It can be
understood as the number of pulses with peak current that the machine
delivers per second. To deactivate the pulsed output set the frequency
0 and set the peak current of the pulsed TIG
working current.
6
TIG AC Wave Balance : Configurable from -5 to 5. It is an adjustment of
the percentage of the positive and negative part of the output AC current
wave.
TIG AC Wave Frequency : The frequency of the AC power output is
adjustable up to 250 Hz.
www.ELITETOOLS.co
Use button on panel
TIG AC wave parameters. The parameters in this
panel are not available for TIG DC.
The configurable parameters in this panel are:
to the same value of the
6 and the knob to modify the
to
21
Keep Working