Uploading A Simpl Windows Program - Crestron C2N-CAMIDSPT Operation Manual

Camera Interface, Digital Servo Pan Tilt Head
A control system source file
has the extension .smw. A
compiled SIMPL Windows
file has the extension .spz
for a 2-Series control
system.
30 • Camera Interface, Digital Servo Pan Tilt Head: C2N-CAMIDSPT
"Port Settings" Window
NOTE: The parameters shown in the illustration above are the port settings for a
2-Series control system. Consult the Operations Guide for the control system being
used for exact parameter selection.
4. To verify communication, select Diagnostics | Establish
Communications (Find Rack). This should display a window that
gives the COM port and baud rate. If communication cannot be
established, refer to the "Troubleshooting Communications" section in
the respective Operations Guide for the control system.

Uploading a SIMPL Windows Program

The SIMPL Windows file can be uploaded to the control system using SIMPL
Windows or via the Crestron Viewport.
Upload via SIMPL Windows
1. Start SIMPL Windows.
2. Select File | Open to view the "Open" window, navigate to the SIMPL
Window file (.smw), and click Open.
3. Select Project | Transfer Program.
Upload via Crestron Viewport
1. Verify that the procedure for "Communication Settings" that begins on
page 28 has been performed.
2. As shown after this step, select File Transfer | Send Program
(alternatively, press Alt+P) from the Viewport menu.
Crestron C2N-CAMIDSPT
Operations Guide - DOC. 6262A