How To Install Your Remote Control - Fanimation KLOUT FP3070 Series Manual

How to Operate Your Ceiling Fan (Continued)
4. To set the remote code in the same positions as
the receiver, use a small screwdriver or ball point pen
(neither included) to slide dip switches firmly up or
down. (Figure 4)
NOTE: Factory setting is all up. Do not use this position.
5. Remote functions: (Figure 5)
• Indicator LED light: fan speed
• button: Turns fan off.
• Fan Speed:
Turns fan on and turns speed up.
Turns fan on and turns speed down.
• Light button: Turns light on and off.
Increases light output level.
Decreases light output level.
• Sleep Timer:
Tap and the fan and light will turn off after
1 hour.
Tap and the fan and light will turn off after
3 hours.
Tap and the fan and light will turn off after
6 hours.
6. If airflow is desired in the opposite direction, turn
the fan off and wait for the blades to stop turning.
Slide the reverse switch on the motor assembly to the
opposite position and turn fan on again. (Figure 6)
Reverse Switch Information
Season Rotation Direction
Summer Clockwise
Winter Counterclockwise

How to Install Your Remote Control

1. Installing Wall Holder: (Figure 1)
Attach wall holder using the two provided screws.
Switch Position
Right
Left
14
ON DIP
1 2 3 4 5
Dip Switch
Figure 4
Figure 5
Figure 6
Figure 1
Remote
Reverse
Switch
Screws (2)
Wall Holder