How To Operate Your Ceiling Fan - Fanimation KLOUT FP3070 Series Manual

How to Assemble Your Fan Blade and Light Bulbs (Continued)
4. Assemble the lower grill to the upper grill assembly
using the previously removed screws. (Figure 4)
1. IMPORTANT: Using a full range dimmer switch (not
included) to control fan speed will damage the fan. To
reduce the risk of fire or electrical shock, do not use a
full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and fan damage
could result.
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
3. To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off. Then follow the remote code setting process.
(If not used for long periods of time, remove battery to
prevent damage to transmitter). Store the remote away
from excessive heat or humidly. (Figure 3)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.

How to Operate Your Ceiling Fan

WARNING
WARNING
Upper Grill Lower Grill
Assembly
For illustrative purposes only-not
intended to cover all types of controls
12V 23A
Battery (1 pcs)
13
Screws (5)
Figure 4
Figure 1
Main Fuse Box
Figure 2
Figure 3