Unpacking Instructions - Fanimation KLOUT FP3070 Series Manual

Table of Contents

Advertisement

Available languages

Available languages

This manual is designed to make it as easy as possible for you to assemble,
Tools Needed for Assembly
(Not Included)
• One Phillips head screwdriver
• One ¼˝ blade screwdriver
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 10). If you feel you
do not have enough wiring knowledge or experience, have
your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been
completed and will be helpful in finding your place should you be interrupted.
Do not install or use fan if any part is damaged or missing. This product is designed to use only those parts supplied with
this product and/or any accessories designated specifically for use with this product by Fanimation. Substitution of parts
or accessories not designated for use with this product by Fanimation could result in personal injury or property damage.
Contact your retail store for missing or damaged parts.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to exploded view illustration.
Hanger Bracket
Ceiling Canopy (1)
Assembly (1)
Canopy Screw Cover
Assembly (1)
Downrod/Hanger Ball
Assembly (1)
– Downrod (1)
– Hanger Ball (1)
Motor Coupling
– Set Screw (1)
Cover Assembly (1)
– Hairpin Clip (1)
– Clevis Pin (1)
– Pin (1)
Hardware Bags
Truss Head Screws M4
Spring Washers
(6)
install, operate and maintain your ceiling fan
• One stepladder
• One wire stripper

Unpacking Instructions

Motor Assembly (1)
Upper Grill Assembly (1)
Acorn Nuts M4
(6)
(6)
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
nstalled
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing, contact your local retailer.
WARNING
Trim Cover (1)
Safety Cable Kit
Wire Connectors
Safety Cable
(4)
4
Materials
ire ength
p to
ft
ft
Blade (1)
LED Bulbs (5)
Blade Holder
Lower Grill (1)
Cable Clamp
(1)
(1)
ire i e
12V 23A
Hand-held Remote (1)
Wall Holder (1)
Screws (2)
Battery (1)
Receiver (1)
Wire Connectors (6)
Flat Washer,
Lag Bolt
Stainless Steel
(1)
(1)

Advertisement

Chapters

Table of Contents
loading

Table of Contents