Table of Contents
Advertisement
Quick Links
WARNING!
!
Incorrect installation or removal of meters
can result in serious injury or death . Read the
instructions in this guide on the proper procedures
carefully.
•
Any person installing, inspecting, or maintaining
a McCrometer flowmeter should have a working
understanding of piping configurations and systems
under pressure.
•
Before adjusting or removing any meter, be certain
the system has depressurized completely.
•
Be careful when lifting meters. Meters can cause
serious injury if lifted incorrectly or dropped.
Electromagnetic Flow Meter
Quick Start Installation Guide
About This Quick Start Guide
This Quick Start Guide is a supplement to the Installation,
Operation and Maintenance manual supplied with this
meter. It is intended to be a quick reference for the basic
installation and reading of the McMag
It is designed to provide installation instructions when the
location of the sensor installation has been predetermined.
Refer to the meter manual (30120-85 McMag
manual) for information on these topis:
•
Preparation and planning for installation
•
Site location
•
Software configuration
•
Detailed information on external connections, external
power, outputs
For information on the data logger, refer to the manual
(30121-87 McLogger IOM), downloadable from www.
mccrometer.com).
About This Quick Start Guide . . . . . . . . . . . 1
1 .
Flow Meter Installation . . . . . . . . . . . 2
2 .
3 .
Converter Wiring and Connection . . . . 4
4 .
Grounding . . . . . . . . . . . . . . . . . . . 6
5 .
Activating The Display . . . . . . . . . . . 6
6 .
Converter Boot . . . . . . . . . . . . . . . . 7
7 .
Converter Configuration . . . . . . . . . . 7
8 .
Page 1
McMag
Battery Powered
30121-64 Rev. 1.6
.
3000
30121-64 Rev. 1.6 | 04OCT2021
3000
October 4, 2021
IOM
3000
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for McCrometer McMag3000
Summary of Contents for McCrometer McMag3000
- Page 1 Grounding . . . . . . . . . . . . . . . . . . . 6 a McCrometer flowmeter should have a working Activating The Display .
- Page 2 3000 The Mc Mag can be used to replace existing McCrometer saddle meters. The Mc Mag 3000 can be installed with Water Place the meter assembly on the pipe with the flat Specialties bolt-on saddle meter cutout templates for 6”...
- Page 3 Connections to the sensor must be made with cable supplied by McCrometer specifically for that purpose. Do not substitute the supplied cable with other types of cable, even for short runs. For repairs or added lengths of cable, the entire cable between the sensor and the converter must be replaced.
- Page 4 3 . Converter Wiring and Connection External Output Connectors The flow meter is configured at the factory for the optional outputs and requested by the customer at the time of order. The external cables attach through a permanent cable gland (standard) or through a screw locking-type waterproof connector (quick connect option).
- Page 5 Green right. Green • Signals and associated wire colors in the McCrometer SmartOutput™ Black interface cable are identified together in the top row of the table above. Black •...
- Page 6 Rate unit There is an optical sensor embedded in the display Total located under the McCrometer “swirl” logo at the lower left. If the display does not appear, a flashlight will provide Total unit sufficient light to bring it up.
- Page 7 6 . Converter Boot The Mc Mag3000 comes with a boot to help protect the To remove the boot, grip two corners and pull them away meter. from the lip of the enclosure and then pull upwards. The boot simply slips over the electronics enclosure. When NOTE: installing the boot insure the corners of the boot fit snugly NOTE...
- Page 8 Copyright © 2021 McCrometer, Inc. All printed material should not be changed or altered without permission of McCrometer. Any published pricing, technical data, and instructions are subject to change without notice. Contact your McCrometer representative for current pricing, technical data, and instructions.
Need help?
Do you have a question about the McMag3000 and is the answer not in the manual?
Questions and answers