Hard Drives - HP ProLiant DL145 Maintenance And Service Manual

Hard Drives

The server's two 1-inch hard disk drive bays support both non-hot-plug SCSI and SATA
drives. Hard drives installed in the server are labeled as Device 0 and Device 1 from left to
right when viewed from the front of the server. Refer to Figure 2-10 for related illustration.
Figure 2-10: Hard drive device numbers
Hard Drive Support
The default system comes with a single hard drive, the type and capacity of which varies
based on the server model. Your ProLiant server currently supports the following drive
capacities:
•
SCSI HDD
− 36 GB
−
The SCSI drive and the 80 GB SATA drive options include only the hard disk. Use the HDD
carriers and mounting screws included with your server to install these drives.
The 160- and 250-GB SATA drive options come with a hot-plug HDD carrier. You need to
remove the drives from their default carriers before installing them in the server. Use the
HDD carriers and mounting screws included with your server to install these drives.
HP ProLiant DL145 Generation 2 Server Maintenance and Service Guide
All manuals and user guides at all-guides.com
72 GB
Removal and Replacement Procedures
•
SATA HDD
− 80 GB
− 160 GB
−
250 GB
2-13