Opening The Server - HP ProLiant DL145 Maintenance And Service Manual

Opening the Server

The top cover is detachable. You need to remove this cover before you can remove or replace
a server component.
To remove the top cover:
1. Perform steps 1 and 2 of the pre-installation procedures described on page 2-5.
2. Detach the top cover from the chassis:
a. Loosen the captive thumbscrew on the rear panel.
b. Slide the cover approximately 1.25 cm (0.5 in) toward the rear of the unit, then lift
Figure 2-1: Removing the top cover
3. Place the top cover in a safe place for reinstallation later.
To reinstall the top cover:
1. Perform steps 1 through 4 of the post-installation procedures described on the previous
page.
2. Reinstall the top cover:
a. Align the cover to the chassis and then slide it towards the front panel to position it
b. Once the cover is attached to the chassis, secure it by tightening the captive
HP ProLiant DL145 Generation 2 Server Maintenance and Service Guide
All manuals and user guides at all-guides.com
the cover to detach it from the chassis.
into place.
thumbscrew on the rear panel.
Removal and Replacement Procedures
2-7