Step 13 - - Adjust Factory- - Installed Options; Step 14 - - Install Accessories - Bryant 581J Installation Instructions Manual

Step 13 — Adjust Factory- -Installed Options
Smoke Detectors —
Smoke detector(s) will be connected at the Controls
Connections Board,
Shutdown". Remove jumper JMP 3 when ready to
energize unit.
EconoMi$er IV Occupancy Switch —
Refer to Fig. 62 for general EconoMi$er IV wiring.
External occupancy control is managed through a
connection on the Central Terminal Board.
If external occupancy control is desired, connect a time
clock or remotely controlled switch (closed for Occupied,
open for Unoccupied sequence) at terminals marked
OCCUPANCY on CTB. Remove or cut jumper JMP 2 to
complete the installation.
Step 14 — Install Accessories
Available accessories include:
Roof Curb
Thru- - base connection kit (must be installed before unit
is set on curb)
LP conversion kit
Manual outside air damper
Copyright 2011 Bryant Heating & Cooling Systems D 7310 W. Morris St. D Indianapolis, IN 46231
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
Economizer
Fig. 62 - - EconoMi$ert IV Wiring
at terminals marked "Smoke
2 Position Damper
High Altitude Gas kits
Flue Discharge Deflector
Flue Exhaust Heat Shield
Low Ambient Controls
Thermostat / Sensors
Two- - Position motorized outside air damper
EconoMi$er2 (without control/for external signal and
integrated barometric relief)
EconoMi$er2 (without control/for external signal)
Power Exhaust
Differential dry- - bulb sensor (EconoMi$er IV)
Outdoor enthalpy sensor
Differential enthalpy sensor
CO sensor
2
Louvered hail guard
Phase monitor control
Winter Start kit
Refer to separate installation instructions for information
on installing these accessories.
Pre- - Start and Start- - Up
This completes the mechanical installation of the unit.
Refer to the unit's Service Manual for detailed Pre- - Start
and Start- - up instructions.
Printed in U.S.A. Edition Date: 04/11
40
Unit Without Economizer or
2 Position Damper
C10150
Catalog No: II581J---10
Replaces: II581J--- 01 & II581J--- 03