Resetting The Ax-Ch5-Swc - Axxess AX-CH5-SWC Installation Instructions Manual

STEERING WHEEL CONTROL SETTINGS
Dual assignment legend
1. Not allowed 4. Seek-Down/Prev
2. Not allowed 5. Mode/Source
3. Seek-Up/Next 6. ATT/Mute
* Not applicable in this application

Resetting the AX-CH5-SWC

1. With the radio on, turn the potentiometer:
Note: Before proceeding, remember the position the potentiometer is at.
Turn left the LED will come on
Turn right the LED will come on
Turn back left the LED will come on
Turn right the LED will come on
Turn back left the LED will begin to flash rapidly
Turn back to the initial position
The rapid flash means the interface is starting its re-programming process.
2. The L.E.D. inside the interface will turn off for a couple seconds, then flash fast, then flash slowly (up to (18) times, indicating
which radio is connected to the interface), and then turn off. Pay close attention as to how many slow flashes there are. This will
help in troubleshooting, if need be. Refer to the L.E.D. feedback section for more information.
3. Within a few seconds the L.E.D. will turn on, and the radio will turn off.
4. Within a minute the L.E.D. will turn off, and the radio will come back on, indicating the resetting and initialization process was successful.
AxxessInterfaces.com
7. Preset-Up 10. Band
8. Preset-Down 11. Play/Enter
9. Power 12. PTT
hold until the LED goes out
hold until the LED goes out
hold until the LED goes out
hold until the LED goes out
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
(CONT)
13. On-Hook 16. Fan-Down *
14. Off-Hook 17. Temp-Up *
15. Fan-Up * 18. Temp-Down *
AX-CH5-SWC
I N S TA L L AT I O N I N S T R U C T I O N S
IMPORTANT
If you are having difficulties with the installation of this product,
please call our Tech Support line at 1-800-253-TECH. Before doing
so, look over the instructions a second time, and make sure the
installation was performed exactly as the instructions are stated.
Please have the vehicle apart and ready to perform troubleshooting
steps before calling.
K
®
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
REV. 7/18/17 INSTAX-CH5-SWC
P
OWER