Lifting & Moving; Test Run - Grizzly T30945 Owner's Manual

Lifting & Moving
The Model T30945 is light enough for one person
to lift and move a short distance.
To lift and move machine:
1. DISCONNECT MACHINE FROM POWER!
2.
Secure rip fence position with rip fence lock
lever (see Figure 17).
Rip Fence
Lock Lever
Figure 17. Rip fence lock location.
3. Lift machine by table edges and move to pre-
pared location.
Model T30945 (Mfd. Since 12/19)

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following: 1)
The motor powers up and runs correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON by pulling switch paddle up,
verify motor operation, and then turn machine
OFF by pushing switch paddle down.
The motor should run smoothly and without
unusual problems or noises.
-17-