Table of Contents
Advertisement
Problem
Parts feed from hopper even though
the hopper is off.
Part movement slows as more parts
are fed onto table.
Table will not run.
332462E
Possible Cause
Vibration from the table is making the
hopper vibrate and feed parts.
Table is not set to Autotrack.
No Power to unit.
M12 Control connection to table is
not properly set up.
Blown fuse.
Troubleshooting
Solution
Adjust the Hopper gate to the optimal
height to help restrict parts feeding.
Reduce the amplitude of the table but
still have acceptable part movement.
Attach the Part Feed Optimizer and
adjust it to the proper height to pre-
vent parts from unintentional feeding.
Adjust Hopper Feed Table Slope up
away from the table. See Hopper
Feed Table Slope, page 11.
Go into menu and set the table to
Autotrack instead of manual mode.
Ensure power is properly connected
and turned on.
Check M12 connection and setup.
Confirm table turns on in Manual
Operation in Override Mode, page
14.
Replace with new fuse.
27
Advertisement
Table of Contents
