I User Alerts - Zodiac Vortex GV 33 Series Installation And User Manual

The screen displays the message
when the remote control
mode is active
The remote control LED is flashing
slowly or the LED is steadily lit.
The remote control LED is steadily
lit.
If the problem continues contact your retailer:

4.2 I User alerts

User alerts (depending on the model)
Flashing LED:
If the problem continues contact your retailer:
Error codes
• Pressing a key deletes the error code and turns off the control box.
• The screen switches to standby after 10 minutes. To turn the screen back on, press any key.
• When an error is detected, the control box temporarily suspends the programme (the
• Press and hold the key to re-confirm the current programming.
• This means that the remote control batteries are too low: change them.
Remote control range problem:
• Position the control box on the caddy at least 3.5 metres from the pool.
• Orient the control box towards the pool in order to improve the range of the
remote control. Ensure there are no large obstacles between the control box
and the pool.
• Synchronisation problem: repeat the synchronisation steps (see § « 2.7.4
Synchronising the remote control with the control box »).
Error code:
• Check that the cleaner is correctly connected to the
Er: 10
control box. If necessary, unplug it and reconnect it
following the appropriate procedure.
Er: 02
• Check that there is nothing preventing the brushes
Er: 03
and wheels from turning. To do so, turn the wheels
Er: 05
(1/4 turn) to release any debris that may be jammed.
Er: 06
• Cleaner operating outside the pool. Make sure you
Er: 07
start the cleaner when it is in the water (see § « 2.1 I
Er: 08
Immersing the cleaner in the pool »).
Er: 01
• Check that there are no stones or hair in the propeller.
Er: 04
• Clean or change the filter if necessary.
Solutions
LED is turned off).
EN
22