Page 1
OWNER'S MANUAL TORNAX Robotic Pool Cleaners EP34-- EP35-- WARNING FOR YOUR SAFETY - For anything other than the routine cleaning and maintenance described in this manual, this product must be serviced by a contractor who is licensed and qualified in pool equipment by the jurisdiction in which the product will be installed where such state or local requirements exist.
If the original dealer does not perform warranty service: Australia and New Zealand Please contact Zodiac Customer Care 1300 763 021 or visit www.zodiac.com.au South Africa Please contact Zodiac Customer Care 0860 887 665 or visit www.zodiac.co.za In the case that your product may require a warranty or service, please retain the original carton to transport your cleaner in.
• Do not bury cord. Locate cord so as to prevent it from being damaged by lawn mowers, hedge trimmers and other equipment. • To reduce the risk of electrical shock, do not use the robotic cleaner or control unit if the cord is worn or damaged. Immediately contact Zodiac Customer Care Service for proper servicing and replacement of the damaged cord: Australia 1800 688 552, South Africa 0860 887 665.
This cleaner is a double-insulated product. A double- Australia and New Zealand please contact Zodiac insulated electrical appliance is one which has been Customer Care 1300 763 021 or visit www.zodiac. designed in such a way that it does not require a safety com.au.
ENGLISH Page 5 Zodiac FX20 FX30 FX35 Robotic Pool Cleaner Owner's Manual ® Connecting to Power Source WARNING Failure to comply with the following warnings can result in permanent injury, electrocution or drowning. PREVENT ELECTRICAL SHOCK • Keep the control unit at least five 3.5 m from the edge of the pool.
• At the end of each cycle, remove the cleaner from the pool. Start at the cleaner head and untangle any coils in the cable before storing the cleaner. • Zodiac reccommends only three cleaning cycles per week. The Zodiac robotic cleaner includes a safety feature that automatically stops the cleaner if it is powered on but not submerged in water.
ENGLISH Page 7 Zodiac FX20 FX30 FX35 Robotic Pool Cleaner Owner's Manual ® Rinsing the Cleaner Stopping the Cleaner and Removing from the Pool Rinse the cleaner after every cleaning cycle. Use slightly soapy clean water, then rinse generously with Press Start/Stop button to interrupt operation.
FX35 models: It is recommended when storing the cleaner for extended periods, use the Zodiac transport caddy Contact your local Zodiac pool specialist for details. To store the cleaner on the caddy: Place cleaner in vertical position on the caddy base and clip to hook.
To maintain cleaner performance at its best you need to replace the brushes as soon as one of the wear indicators has been reached (even if the blade wear is not even). Zodiac Pool Systems, Inc. recommends that you replace the brushes every two (2) years.
Unplug the floating cable from the LED flashes once control unit and reconnect. with one second If the problem persists, contact interval. Zodiac Customer Care: 1300 763 021 (Australia) or 0860 887 665 (South Africa). 2 Flashes Turn cleaner wheels to ensure LED flashes twice they are not jammed.
Page 11
Cleaner may not be fully submerged. Remove cleaner from the pool and re-submerge, button for less than 20 Propellor may be jammed and not Contact Zodiac Customer Care: 1300 763 021 seconds). turning correctly. (Australia) or 0860 887 665 (South Africa).