Gameplay
Operating the Robot Using a Gamepad
Introduction
Users can connect the Gamepad to a mobile device to control the robot in the following ways:
1. Using the gamepad connected to a mobile device.
2. Using the gamepad connected to a mobile device with a mouse attached.
3. Using the gamepad connected to a mobile device with a mouse and keyboard attached.
Connecting the Gamepad
Connect the mobile device to the mobile device port on the gamepad using a micro USB cable
(not included).
Adjust the mobile device clamp to secure it to the gamepad. Make sure the mobile device is
connected with the cable facing toward the control stick as shown in the figure below.
Press the power button to power on the gamepad. Press and hold the power button to power off
the gamepad.
Gamepad Basic Operation
When the gamepad is connected to a mobile device, the control stick on the gamepad is used to
move the robot forward, backward, and sideward. The app cannot be used to control the chassis.
The buttons on the gamepad can be used to perform actions on the robot. Users can also
continue use the app to perform these actions.
Using the Gamepad
The control stick on the gamepad is used to control the chassis. The app is used to perform other
actions. When the gamepad is connected, it is not possible to move the chassis using the app.
Using the Gamepad and Mouse
After the gamepad is connected to a mobile device, a computer mouse can also be connected to
the gamepad. The control stick on the gamepad is used to control the chassis. The mouse actions
are listed below, which can also be performed by the app, but the mouse is the primary controller.
Control Stick
Movement
Movement
前
后
The control stick on the gamepad is used to move the robot
forward, backward, and sideward.
Robot
Control Stick
Movement
Forward
前
前
前
左
左
Backward
后
后
后
Mouse Action
Right click
Move mouse
©
2020 DJI All Rights Reserved.
Robot
Movement
右
Left
Right
左
右
左
右
右
Robot Action
Zooms in
Controls the chassis
51
Need help?
Do you have a question about the Robomaster EP Core and is the answer not in the manual?