dji Robomaster EP Core User Manual page 33

5. As shown below, connect the XT30 power cable in the chassis cabin to the 12V power input
port and the B end of the 12cm data cable to the CAN bus port of the power connector module.
Secure the module at the chassis cabin.
LED Indicator Description for Power Connector Module
The LED indicator is used to indicate the status of the power connector module. Details are as
follows:
LED Indicator
Solid white
Solid red
Off
Power Connector Module Status
Normal power input and 5V output
Normal power input, but 5V output has an overcurrent or
is short-circuited
Abnormal power input
ROBOMASTER EP Core User Manual
©
2020 DJI All Rights Reserved.
33