Ricoh Pro C9100 Series Technical Bulletin page 11

Model:
BR-C1/BR-P1
Adjustments
Code
 Do the following.
J430
1. Fan and decurl the paper.
J431
J445
2. Set No. 41 [Paper Feed Mode (Adjust Fan Level)] in Advanced
J446
3. If the above does not solve the jam, change the setting to [Max
 If none of the above solves the jam, do the following.
If dog ears occur on the jammed paper, and you are printing onto thin
paper:
Set No. 40 [Switch Paper Load Upper Limit] in Advanced Settings to
[High].
 Do the following.
J470
1. Make sure the Paper Size has been set correctly, and then fan/decurl
J471
J485
2. Set No.41 [Paper Feed Mode (Adjust Fan Level)] to [Moderate Dble
J486
 If the above does not solve the jam, change this setting to [Max Dble Fd
Reduc. (Lowest)].
 If none of the above solves the jam, do the following.
If the paper curl is too strong, even after decurling:
1. Set No.39 [Side Fan Shutter] to [Active].
If you are using paper with high porosity such as recycled paper:
1. Increase No. 37 [Vacuum Fan] in Advanced Settings by +10%.
If you are using small envelopes:
1. Decrease No.34 [Updraft Fan] to [0].
Tips
Burrs on the paper edges may disturb the air flow and cause feeding problems. Fan the
paper to remove the burrs.
T
echnical
Settings to [Moderate Nonfdg Red. (Higher)].
Nonfdng Reduc. (Highest)].
the paper.
Fd Red. (Lower)].
B
ulletin
Date:
28-Sep-15
Action
PAGE: 2/8
No.:
RD777003