Advertisement
4
Taking pictures
1
Turn the Mode Dial to Snapshot mode (the camera icon on the mode dial).
Press the [Power] button to turn on the camera.
2
When the LED indicator glows green, the camera
is ready to take a picture.
3
Check the battery level in the LCD status display.
(Refer to "Inserting the batteries" if necessary).
4
Press the [Strobe/Copy] button to cycle through the four flash modes:
Auto > Always On > Red-Eye Reduction > Off
Press the shutter button and keep the camera still until you hear a beep. This
5
indicates picture has been taken.
Note: Moving the camera after the shutter release and before the
beep will cause motion blur.
5
Using the Mode Dial
The Mode Dial allows you to select the operational mode of the
camera. The six operational modes are: Video, Preset,
Snapshot, Playback, Setup and PC Camera.
2
6
After you have taken a picture, the number shown in the LCD status display
will decrease by 1 unit. (This display indicates the approximate number of
pictures remaining.)
Warning: In order to avoid any loss of data, wait until the image is
finished being stored (the LED lights up again) after taking a
picture before turning the power OFF.
CAUTION
Leaving LCD Display on will drain batteries
To save battery power, it is recommended that you turn off the LCD display
whenever you are not taking pictures. The camera has a built-in auto-off
function which will turn the LCD or the power off after 3 minutes of inactivity.
After this time, the camera will beep 6 times and the Power OFF Mode will
Shutter
automatically activate. During the Automatic Power OFF Mode, the LCD
status display turns off and the LED lamp goes out. To start taking pictures
again, turn the power OFF, wait one second, and then turn the power
back to ON.
Video
PRE SET
Preset
Snapshot
Playback
Setup
PC Camera
Allows you to record a 28-second video movie to your
camera's on-board memory or SD/MMC card. (If the
inserted card is more than 16MB, you can record up
to a maximum of 60 seconds of video.)
Takes pictures with one of five pre-defined templates.
The standard mode for taking pictures.
View stored pictures.
Modify settings such as display language, flash, etc.
Use in conjunction with any commercially available video
capture software to create your own home videos.
Advertisement
