Table of Contents
Advertisement
Using the pre-programmed Extron EDID
N
1.
Choose a resolution from Table 1 based on the native resolution
of the display. Note the corresponding rotary switch position.
2.
To use the EDID, set the rotary switch (
position (1-F) selected in step 1. The switch clicks as
it moves through the positions.
Table 1 — Rotary Switch position
N
3.
Set the first DIP switch (
vertical refresh of the native rate of the display.
(default is ON, 60 Hz).
For the EDID 101D only, choose digital or
4.
analog based on the input signal format.
5.
Install the EDID 101 into the system.
EDID 101D/EDID 101V • Installation and Operation
Configuring the EDID 101 rotary and DIP switches allow
a user to select a pre-programmed EDID based on the native
rate of a display (i.e. 1280x1024 @ 60 Hz) and a desired
signal type (i.e. digital), but does not necessarily force a video
source to output that rate.
Since EDID is not limited to reporting a single video rate
(i.e. the native rate), each Extron EDID also lists other
common video rates for use by the video source.
Rotary Switch
Position
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
When using a dual link DVI display with the EDID 101D
(position F), only two resolutions will be shown to the video
source, 1280x800 and 2560x1600.
d
Resolution
User Recorded EDID
800x600
1024x768
1280x720
1280x768
1280x800
1280x1024
1360x768
1366x768
1400x1050
1440x900
1600x1200
1680x1050
1920x1080
1920x1200
Digital: Dual Link DVI
Analog: Not Used
c
) based on the
) to the
ON
60
Hz
50
1 2
4
DIGITAL
SIGNAL
ANALOG
11
Advertisement
Table of Contents
