Exhaust Hose Installation; Installation Instructions - Vivax ACP-12PT35AEH R290 User Manual

Fig.16a
Fig.16b
Hole seat
Hook
Expansion plug
position
Adaptor A
Adaptor
cap

Exhaust hose installation:

The exhaust hose and adaptor must be installed or removed
in accordance with the usage mode.
1. Install the adaptor B and adaptor I onto the exhaust hose as
2. Resert the hook of the Exhaust hose into the hole seat of the
Fig.17
The exhaust hose can be installed into the wall
(Not applicable to the units without adaptor A, expansion
plugs and wooden screws of Accessories ).
1. Prepare a hole in the wall. Install the wall Exhaust adaptor A
onto the wall(outside) by using 4 expansion plugs and
wooden screws, be sure to fix thoroughly. (See Fig.18)
2. Attach the Exhaust hose to wall Exhaust adaptor A.
Note:
Cover the hole using the adaptor cap when not in use.
max 120CM
min 30CM
Fig.18
IMPORTANT:
DO NOT OVER BEND THE EXHAUST HOSE (SEE Fig.19)
Make sure that there is no obstacle around the air outlet of
the exhaust hose (in the range of 500mm) in order to the
exhaust system works properly.
Fig.19

INSTALLATION INSTRUCTIONS

COOL,HEAT(heat pump type) or AUTO
mode
FAN,DEHUMIDIIFY or HEAT(electrical heat type) Remove
mode
shown in Fig.16a or Fig.16b. Refer to the previous pages for
window kit installation.
air outlet and slide down the Exhaust hose along the arrow
direction (See Fig.17) for installation.
The exhaust hose can be compressed or extended
moderately according to the installation requirement,
but it is desirable to keep the hose length to a minimum.
CAUTION:
Install
12