Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for FAAC E391
Summary of Contents for FAAC E391
- Page 1 E391...
-
Page 2: Table Of Contents
• conforms to the essential safety requirements of the following EEC directives: 73/23/EEC and subsequent amendment 93/68/EEC. 89/336/EEC and subsequent amendment 92/3/EEC and 93/68/EEC Additional information: This product underwent a test in a typical, uniform configuration. (all products made by FAAC S.p.A) Bologna 0-09-2006. The Managing Director A. Bassi WARNINGS •... -
Page 3: Warnings
CONTROL UNIT E391 1 WARNINGS Before attempting any work on the control unit (connections, maintenance), always turn off power. - Install, upstream of the system, a differential thermal breaker with adequate tripping threshold, - Always separate power cables from control and safety cables (push-button, receiver, photocells, etc.). -
Page 4: Technical Specifications
3 TECHNICAL SPECIFICATIONS 3.2 DESCRIPTION OF TERMINAL-BOARDS Power supply voltage 230Vac (+6% -0%) - 50Hz Terminal and/or Description Device connected terminal-board Absorbed power Motor max. load 50W x 2 Power supply for +24V accessories Accessories max. current 00 mA (+24V) Negative BUS Accessories max.current 400 mA Device with NC Operating ambient tempera-... -
Page 5: Start-Up
6.4 TIME - SETUP LEARNING 6. START-UP 6.1 LEDS CHECK Before any manoeuvre is executed, a SETUP cycle must first be run. The following table shows that status of the LEDs in relation to the status of the inputs (the closed at rest automated system During SETUP do not interrupt the photocells condition is shown in bold). -
Page 6: Installation Of Bus Accessories
If the AP Logic was selected, the board begins to count the pause time (max 0 min) and, after the required time has elapsed, give an OPENING pulse to continue the pro- cedure. Otherwise, if you have selected the EP logic, give an OPEN pulse to continue the procedure. -
Page 7: Memory Storage Of Bus Accessories
7.2 MEMORY STORAGE OF BUS ACCESSORIES You can add the BUS photocells to the system at any time, simply by memory-storing them on the board, observing the following procedure: Install and program the accessories using the required address (see paragraph 7.) Cut power to the board. Connect the two accessories cables to the red terminal- board J0 (any polarity will do). -
Page 8: Memory Storage Of Lc Radio Controls (For Some Markets Only)
Quickly press twice the memory stored radio control push- Within 5 sec. press the push-button of the radio control button. that had been memory stored to enable learning on the selected channel. The LED on the board relating to the channel being learned The automated system performs one opening flashes for 5 sec., within which time the code of another operation. Make sure that the automated... -
Page 9: Logic Tables
11 LOGIC TABLES... - Page 10 Les descriptions et les illustrations du présent manuel sont fournies à titre indicatif. FAAC se réserve le droit d’apporter à tout moment les modifications qu’elle jugera utiles sur ce produit tout en conservant les caractéristiques essentielles, sans devoir pour autant mettre à...