Magura CLARA Manual page 16

w w w . m a g u r a . c o m
s e r v i c e @ m a g u r a . d e
3. Prepare the transparent filler tube by pushing in by hand the M6 barbed fitting.
Put the other end of the filler tube on the syringe and fill the syringe completely with
MAGURA BLOOD mineral oil. Fill the syringe completely and make sure that there are
no air bubbles inside. Turn the syringe eventually to push out air bubbles.
4. Remove the brake pads as described on page 12 and slide the YELLOW trans-
port device as shown with its THICK END between the caliper pistons. Squeeze slightly
the lever blade (pump) to tighten the transport device. Only use the YELLOW trans-
port device for this procedure, the formerly used black one is not suitable for
this work!
5. Fix the caliper so that the connecting bolts of the caliper (arrow) are positioned
horizontally. It might be necessary that you have to unscrew the lower caliper fitting bolt
and to fix the caliper as shown. Unscrew bleeding screw with a 3mm Allen key. Screw in
the prepared syringe and tighten it by hand.
Place now a rag, which has to be free of oil or lubricants around the reser-
voir and, more important, around the brake caliper. Care for a clean working
environment. No dirt or particles may come into the brake system!
6. Unscrew the Torx T7 reservoir cover screw and remove the cover with the mem-
brane sitting below. Begin to slowly press the oil contents of the filling syringe through
the system until no further air bubbles can be seen
7. Press the MAGURA BLOOD oil through the system. Use a second syringe to
suck any overflowing oil. at the reservoir. Then pull the filler syringe to suck oil back.
Repeat procedure 3-4 times and actuate CAREFULLY the lever blade simultaneously.
Make sure that there is always enough oil in the reservoir when you suck the
oil with the filling syringe.
8. Use the second syringe to suck any overflowing oil. The rag around the brake
lever and the caliper prevents overflowing oil from dropping down and contaminating
and killing the brake pads. Push the complete contents of the filling syringe through
the system.
9. The reservoir has to be full to the top before replacing the membrane and the
cover.
16